Speck-electronics EQ16 Manuel d'utilisateur télécharger pdf (Page 7)

To avoid personal injury, do not remove the top cover from the power

supply, or the rear panel of the Model EQ16 and never operate the

external power supply without the cover properly installed. If it

becomes necessary to remove the rear panel of the EQ16 for service,

always unplug the AC power and disconnect the DC interface cable

before proceeding.

The EQ16 is available in two versions: The EQ16-16; 16 mono three

band equalizers, and the EQ16-32; 16 stereo three band equalizers. The

EQ16 may be connected virtually anywhere in the line level audio path

of professional equipment where equalization is required.

The Model EQ16 is a 3 rack space chassis that incorporates 16

independent channels of three band semi-parametric equalizers. Its

versatility and applications are limited only by your imagination. The

Model EQ16 is well suited in audio applications from professional

recording, sound contracting, public address, stage, or any application

where equalization is required.

Some of the many applications of the Model EQ16 is when interfaced to

the Speck Electronics Xtramix or any one of the many commercially

available recording mixers that lack the complete 3 sweepable bands of

the Model EQ16, or lack equalization altogether.

The Model EQ16 will accept a wide variety of signal levels. From the

wide range of levels developed from synths or samplers (typically

-20 dBu to +10 dBu) to the highest levels developed by professional

recorders (typically +4 dBu to +22 dBu).

Each channel of the Model EQ16 is divided into 3 bands; the low

frequency band, mid frequency band, and high frequency band. Each

band has 2 controls; the frequency sweep control and boost/cut control.

The Model EQ16 is supplied with an external rack mount regulated

power supply. The Model EQ16-16 (16 mono channel version) is

supplied with the Model PS3-0.8 power supply. The Model EQ16-32

(16 stereo channel version) is supplied with the higher powered Model

PS3-1.5 power supply.

Both versions of the PS3 power supply include a IEC power entry

connector, a 3 conductor AC power cord, and a 6 foot DC cable. The

DC cable has a 6 pin connector at one end that plugs into the power

supply, and a 6 pin connector at the other end that plugs into the EQ16.

This cable may be secured to the rear chassis of the EQ16 for a positive

connection.

Do not remove covers or panels

General Description

Standard Accessories

Model PS3 power supply

Chapter 1 Introduction Section

1 2 3 4 5 6 7 8 9 10 11 12 ... 32 33

Pas de commentaire

Speck-electronics EQ16 Manuel d'utilisateur Page 7