Speck-electronics EQ16 Manuel d'utilisateur télécharger pdf (Page 15)

Interfacing the Model

EQ16 Equalizer

To clean the front or rear panel, wipe the surface gently using a soft lint-

free cloth to avoid scratching the panel or markings. Paper towels are

not recommended. Commercially available window cleaner solutions

may be used; however, the solution should be applied to the cloth and

not the panel to avoid the seepage of liquid to the inside of the

enclosure.

The Model EQ16 is available in two versions: The EQ16-16; 16 mono

channels, and the EQ16-32; 16 stereo channels. Each channel of the

EQ16-16 has two jacks; one input and one output. Each channel of the

EQ16-32 has four jacks; left and right inputs jacks and left and right

outputs jacks.

Any channel of the EQ16-32 stereo version may be utilized as mono

channel by simply connecting to the left/mono input and left/mono

output jacks.

Connections to each equalizer channel should be made with standard

balanced tip , ring, and sleeve (TRS) 1/4" plugs as shown in Figure 3.

Switchcraft brand #297 or #597 plugs are recommended.

Virtually any line level signal may be connected to the inputs of the

Model EQ16; Synths and samplers, mixing consoles (patch points, line

inputs, effects returns, effects sends), multitrack DAT recorders, hard

disk recorders, analog tape recorders, cassette recorders, CD players,

external mike preamps, and effects.

Cleaning

IMPORTANT!

DO NOT USE BRUSHES OR FEATHER DUSTERS TO

REMOVE DUST. THIS MAY CAUSE DUST TO FALL

INTO THE OPENINGS AROUND THE

PUSHBUTTON SWITCHES.

Things that can be interfaced

to the Model EQ16

Fig 3. Tip, Ring, sleeve (TRS) plug

Chapter 3 Installation Section

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 32 33

Pas de commentaire

Speck-electronics EQ16 Manuel d'utilisateur Page 15